Updater: disable button Start Teamspeak if updater is going to start it automatically

[shadow_lmd]

When autoupdating, updater starts TeamSpeak automatically when update is finished. But Start TeamSpeak button is active as well, and I sometimes press it and get two teamspeak copies launched in the end. That even caused some problems once.

[dante696]

Please do not use the parameter -nosingleinstance and the start button at the same time.

[shadow_lmd]

I do not use anything. I just accept automatic update and when it's done, it shows "Start TeamSpeak" button. I click it and it starts two TeamSpeak instances. I understand that I just dont have to press the button, but I do it automatically sometimes. Anyway, why updater even enables this button if it's running in "autostart mode"?

[dante696]

The update should start the client automatically after the update.
Are you sure you had updater 3.0.3 running?

[shadow_lmd]

It does start it automatically. But there is a few seconds delay after update finished and before TeamSpeak is started. And in this time button Start TeamSpeak is active and clickable. So, the problem is that I press the button, it launches TeamSpeak, and then updater launches TeamSpeak again.

[dante696]

Ok we will check that. I guess it should be possible to block this button completely, while the update was started from the client itself.

[shadow_lmd]

Yes, that's exactly what I meant. Sorry for confusion.

[dante696]

I never noticed that I have send it to a co-worker for more testing

[PeterS]

Changed as suggested, button stays disabled when autostarting the TS3 client.

[shadow_lmd]

Thank you.